Hobart CL44E Commercial Dishwasher

Manufacturer: Hobart

Model: CL44E

Condition: Used. This system is in Fair cosmetic condition. It looks good from a short distance away but up close you will notice lots of hard water residue on the Entrance side, inside, at one port on the rear panel, and on top of the booster. There are typical scuffs/scratches from prior use as well. The flue pipes on both ends have sharp cut-off welds and slightly dented ends. The wire connecting the table and the washer has been cut. The switch on the end of the table has a rusty spring but still pulls to operate the switch.

The photos show the exact item(s) the buyer will receive.

Notes: This system is in Good working condition; it was removed from working service at a local educational institution.

No manuals, cords/cables, or additional items are included if not listed or shown.

Included:

• (1) Hobart CL44E Conveyor Dishwasher
• (1) Hatco S-27 Booster Water Heater
• (1) Clean Dishtable

Specifications:

• Manufacturer: Hobart Corporation
• Model: CL44E
• Commercial Dishwasher
• Power: 480V 3phase 60Hz 27.9A
• 22kW tank heater
• Clean up to 202 racks per hour
• Opti-RinSe system
• Insulated, interlocked, double hinge inspection doors
• Thermal Layer Curtains help keep heat inside
• Exhaust requirement: Entrance 200CFM, Discharge 400CFM
• Stainless steel construction
• Drain stub included as shown
• 
  
• Hatco Model S-27 Imperial Water Heater
• Temperature booster (up to 180ºF)
• 16 gallons capacity
• Recovery rates: 271 GPH @ 40ºF rise, 155 GPH @ 70F rise
• Power: 480V 50-60Hz 3phase 27kW 32.5A
• Without LCD
• 
  
• Clean Dish Table is unbranded
• 8' long
• 6' x 1' shelf on top
• The switch on left end signals the dishwasher when the table is full
• Four legs will stand on its own

SKU: X27D004

6-BILR2(1)

1175lbs - 106in x 73in x 80in