Tayor soft serve - milkshake combo unit

Made in the USA

On wheels

208/230 volt - 3 phase - 9.4 kw

The Model C602 is a combination shake and soft serve freezer. The soft serve side uses a 3.4 qt. (3.2 L) freezing cylinder with a single-spout door. The shake side has a 7 qt. (6.6 L) freezing cylinder with a four-flavor dispensing door.

The touch panel has four flavor symbols for selecting and drawing the desired shake flavor. When dispensing a shake, the cup is placed on the shake cup holder below the door spout. A shake flavor symbol is selected to automatically raise the draw valve, allowing frozen mix and syrup to enter the door where they are blended and dispensed as a finished shake. A portion control device will sense the filling of the shake cup and automatically close the draw valve upon filling the shake cup to the correct level.

The operator also has the ability to override the portion control and stop dispensing the shake by pressing any of the four shake flavor symbols. The shake draw valve can also be raised and lowered in the Wash and Off modes by selecting any of the four flavor symbols to enable cleaning, sanitizing, and priming. Shake syrup is stored in the lower front compartment.

Each syrup flavor is delivered to the dispensing door by a peristaltic pump. Syrup can be pumped directly from disposable plastic jugs or stainless steel tanks, or adapted to syrup-in-bag dispensing. The proper syrup delivery rate is achieved by calibrating each syrup flavor. The mix is located in the mix hopper and is pumped to the freezing cylinder by an air/mix pump. When your machine is delivered, or if it has been in the OFF position for more than 24 hours, disassemble the freezer following the Manual Brush-Cleaning procedures on page 48.

Follow the Equipment Setup procedures on page 59 to reassemble your machine. The machine must be disassembled, cleaned, sanitized, and lubricated at least once every 2 weeks.

Syrup lines must be cleaned and sanitized weekly. It is recommended that these operating procedures be followed closely to ensure correct assembly and disassembly of the freezer.

The C602 is designed for indoor use only